DIVERSIFIED INDUSTRIAL CONCEPTS -- VARNISH INTERIOR -- 8010-00-168-8810 
=====================  Product Identification  =====================

Product ID:VARNISH INTERIOR
MSDS Date:01/11/1994
FSC:8010
NIIN:00-168-8810
=== Responsible Party ===
Company Name:DIVERSIFIED INDUSTRIAL CONCEPTS
Address:228-A PATTERSON AVENUE
City:HAMPTON
State:VA
ZIP:23669
Country:US
Info Phone Num:804-722-5691
Emergency Phone Num:800-424-9300 (CHEMTREC)
Preparer's Name:B GARDIER
CAGE:0SN93
=== Contractor Identification ===
Company Name:DIVERSIFIED INDUSTRIAL CONCEPTS
Address:228-A PATTERSON AVENUE
Box:City:HAMPTON
State:VA
ZIP:23669
Country:US
Phone:804-722-5691
CAGE:0SN93

=============  Composition/Information on Ingredients  =============

Ingred Name:MINERAL SPIRITS (SARA III) (VAPOR PRESSURE 2 MM HG @ 68F)
CAS:64475-85-0
RTECS #:PY8240000
Fraction by Wt: 54%
Other REC Limits:NONE RECOMMENDED
OSHA PEL:500 PPM
ACGIH TLV:100 PPM

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:INHAL: NASAL & RESP IRRITATION,
    DIZZINESS, FATIGUE, NAUSEA, HEADACHE, UNCONSCIOUSNESS,
    ASPHYXIATION. SKIN: IRRITATION. EYES: SEVERE IRRITATION, REDNESS,
    TEARING, BLURRED VISION. ABSORPTION: MAY CONTRI BUTE TO OVERALL
    EXPOSURE. INGEST: GASTROINTESTINAL IRRIT, NAUSEA, VOMITING,
    DIARRHEA. ASPIRATION INTO LUNGS MAY BE FATAL
Effects of Overexposure:ACUTE: IRRITATION OF SKIN, EYES, MUCOUS
    MEMBRANES, DRYING, DEFATTING OF SKIN. AVOID INGESTION AND BREATHING
    OF VAPORS. CHRONIC: EYE, LIVER, KIDNEY, AND CENTRAL NERVOUS SYSTEM
    DAMAGE MAY OCCUR.
Medical Cond Aggravated by Exposure:MAY PROVOKE ASTHMATIC RESPONSE IN
    PERSONS WITH ASTHMA WHO ARE SENSITIVE TO AIRWAY IRRITANT.

=======================  First Aid Measures  =======================

First Aid:IF SPILLED ON THE SKIN OR IN THE EYE, WASH WITH COPIOUS
    QUANTITIES OF WATER, CONTACT PHYSICIAN IF  SPILLED IN THE EYE. IF
    INGESTED, DO NOT INDUCE VOMITING, KEEP PERSON WARM, QUIET AND
    CONTACT PHYSICIA N. BREATHING: REMOVE PERSON TO FRESH AIR. GIVE
    OXYGEN IF BREATHING DIFFICULT; GIVE ARTIFICIAL RESPIRATION IF
    BREATHING STOPS. KEEP PERSON WARM AND GET MEDICAL HELP.

=====================  Fire Fighting Measures  =====================

Flash Point Method:PMCC
Flash Point:>104F,>40C
Lower Limits:1.0
Upper Limits:7.6
Extinguishing Media:FOAM, CO2, DRY CHEMICAL
Fire Fighting Procedures:WEAR SELF-CONTAINED BREATHING APPARATUS WITH A
    FULL FACE PIECE OPERATED IN PRESSURE-DEMAND OR OTHER POSITIVE
    PRESSURE MODE WHEN FIGHTING FIRES.
Unusual Fire/Explosion Hazard:VAPOR HEAVIER THAN AIR MAY TRAVEL ALONG
    GROUND/BE MOVED BY VENT & IGNITED BY HEAT, PILOT LIGHTS, OTHER
    FLAMES & IGNITION SOURCES DISTANT FROM HANDLING POINT.

==================  Accidental Release Measures  ==================

Spill Release Procedures:DIKE UP & CONTAIN SPILL WITH INERT MATERIAL,
    MOP UP AND PLACE MATERIAL INTO CONTAINERS. PREVENT RUN-OFF TO
    SEWER, STREAMS. NOTIFY AUTHORITIES.

======================	Handling and Storage  ======================

Handling and Storage Precautions:DO NOT STORE OR USE IN HIGH
    TEMPERATURE AREAS OR NEAR HEAT, SPARKS, OR FLAME. KEEP CLOSURE
    TIGHT AND CONTAINER UPRIGHT TO PREVENT LEAKAGE.
Other Precautions:STORE ONLY IN VENTILATED AREA. AVOID CONTACT WITH OR
    BREATHING OF VAPORS RELEASED DURING CURING PROCESS. DO NOT INGEST.
    AVOID CONTACT WITH SKIN & EYES. AVOID BREATHING OF VAPORS OR SPRAY
    MIST. OBSERVE  ALL HAZARD PRECAUTIONS GIVEN IN MSDS.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IF TLV OF PRODUCT/COMPONENT EXCEEDED, NIOSH/MSHA
    APPROVED AIR SUPPLIED RESPIRATOR ADVISED IN ABSENCE OF
    ENVIRONMENTAL CONTROL. OSHA REGS ALSO PERMIT OTHER RESPIRATORS
    UNDER SPECIFIC CONDITION. IMPLEME NT ENGINEERING/ADMINSTRATIVE
    CONTROLS.
Ventilation:PROVIDE SUFFICIENT MECHANICAL (GENERAL &/OR LOCAL EXHAUST)
    VENTILATION TO MAINTAIN EXPOSURE BELOW TLV(S).
Protective Gloves:WEAR RESISTANT GLOVES (NIRILE RUBBER).
Eye Protection:CHEMICAL SPLASH GOGGLES.SEE IF OTHERS OK
Other Protective Equipment:TO PREVENT REPEATED OR PROLONGED SKIN
    CONTACT, WEAR IMPERVIOUS CLOTHING AND BOOTS.
Work Hygienic Practices:WASH HANDS BEFORE EATING, SMOKING, OR USING
    WASHROOM.
Supplemental Safety and Health

==================  Physical/Chemical Properties  ==================

HCC:F4
Boiling Pt:B.P. Text:281 TO 388F
Vapor Density:> AIR
Spec Gravity:0.87 (WATER=1)
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NOT SOLUBLE IN WATER
Appearance and Odor:TRANSPARENT AMBER LIQUID WITH MINERAL SPIRITS
    SOLVENT ODOR.

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:NEVER USE WELDING OR CUTTING TORCH ON OR
    NEAR DRUMS (EVEN EMPTY) BECAUSE PRODUCT (EVEN RESIDUE) CAN IGNITE
    EXPLOSIVELY.

====================  Disposal Considerations  ====================

Waste Disposal Methods:SMALL:ALLOW VOLATILE PART TO EVAPORATE IN HOOD
    (ALLOW TIME FOR VAPOR TO CLEAR HOOD DUCT WORK).DISPOSE OF REMAINING
    MAT'L IN ACCORD W/REGS. LARGE:DESTROY BY LIQ
    INCINERATION.CONTAMINATED ABSORBNT MAY B E PUT IN LANDFILL IN
    ACCORD W/FED,STATE,LOCAL REGS

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.